Goldring 2300
All Goldring 2000 series cartridges feature Moving
Iron technology. This lends them the high levels of detail associated
with more expensive moving coil designs whilst retaining the convenience
of a replaceable stylus and high output associated with moving magnet
types. The cartridge employs a fixed samarium cobolt magnet and high
output coil combination so that a very light iron/nickel cantilever
end-piece can be used instead of the much heavier permanent magnet used
in conventional designs. This reduces the moving mass of the cartridge
allowing the stylus to trace the record groove more faithfully. Because
of their high output, Goldring 2000 series cartridges should be used
with the standard moving magnet phono input of an integrated amplifier.
Use of an elliptical nude-diamond stylus offers high frequency
clarity and excellent transient response due to its lower tip-mass
compared to bonded types. This record cartridge will upgrade many
mid-range turntables, allowing them to produce an even finer sound.
Moving "Iron" Generator
A diamond stylus tracing the average record groove will experience
accelerations of up to one thousand gravities. This means that in a
moving magnet design the permanent magnet is subjected to similar
accelerations and if its mass is too large its inertia will result in
poor transient response, distortion and mis-tracking of the stylus. The
2000 series cartridges use a fixed magnet design so that the mass of the
magnet is completely isolated by the compliance of the cartridge
suspension and a much smaller and lighter iron/nickel alloy tube can be
used instead. Attached to the cantilever, the alloy tube is used to
perturb the stationary magnetic field provided by the large fixed magnet
and thus provide the changing magnetic flux necessary to generate the
signal voltage in the coils. Modern samarium cobalt magnets have a super
high energy output and so a much lighter magnet can be employed than
ever before giving the completed assembly a similar mass to traditional
moving magnet types. In this way the cartridge enjoys the convenience
and flexibility of a traditional moving magnet design with a replaceable
stylus block and a high output compatible with standard MM input
stages. At the same time it enjoys some of the refined sound and detail
retrieval previously only available from more costly moving coil
designs.
Threaded Inserts
The cartridge body benefits from integrated M2.5 threaded mounting
holes which means that it is very easy to mount onto the tonearm
negating the need for fiddly washers or nuts which need to be
counter-held during adjustment.
Frequency Response
20 Hz - 20 kHz +/- 3 dB
Channel Balance
within 2 dB @ 1 kHz
Channel Separation
better than 20 dB @ 1 kHz
Sensitivity
6.5 mV ±1.5 dB, 1 kHz @ 5 cm/sec
Vertical Tracking Angle
24°
Stylus Radius
Nude Elliptical
Load Capacitance
100 - 200 pF
Internal Inductance
680 mH
Cartridge Mass ( inc. fixing screws)
8.6 g
Fixing Centre
0.5" (12.7 mm)
Playing Weight
1.5 - 2.0 g (1.7 g nom.)
For more information, please visit this product's webpage.
